{"id":"gcode-g92-1","model_id":"G92.1","name":"LinuxCNC G92.1","summary":"G92.1 is a LinuxCNC G-code that turns off any active G92 coordinate system offsets and clears the stored offset parameters 5211 through 5219 to zero. It is used to erase offsets left over from a previous program so they are not reused. It affects only G92 offsets, not the G53-G59.3 coordinate system offsets.","study_notes":["G92.1 turns off G92 offsets and resets parameters 5211-5219 to zero.","G92.1 only clears G92 offsets; to change G53-G59.3 coordinate system offsets in G-code use G10 L2 or G10 L20.","LinuxCNC stores G92 offsets and reuses them on the next run of a program; G92.1 erases them, while G92.2 removes them but keeps parameters 5211-5219 available.","G92.3 sets the G92 offset back to the values saved in parameters 5211 to 5219."],"safety_notes":[],"sources":[{"url":"https://linuxcnc.org/docs/html/gcode/g-code.html#gcode:g92.1-g92.2","title":"G-Codes","accessed":"2026-10-26"}],"verification":{"status":"source_checked","checked_at":"2026-10-26","values":3,"method":"llm_source_check"},"updated_at":"2026-10-26","type":"instruction","spec":{"language":"gcode","code":"G92.1","group":"Reset G92 Offsets","syntax":"G92.1","parameters":[],"dialect":"LinuxCNC","related":[],"standards":[]},"url":"https://machineschema.com/instruction/gcode-g92-1","license":"https://creativecommons.org/licenses/by/4.0/"}